Windows Characteristics of Thiessen

1. Increased heat due to the width of 71 mm and 5 air chamber width of not less than 5mm.
Practice and calculations show that the profile width of about 60 mm in terms of increased heat exhausted its potential for development. The most recent attempt was the idea of turning the profiles of 60 mm in chetyrehkamernye, and apply amplifying steel termorazryvami, on the aluminum. But research and testing in all European laboratories showed a lack of difference in teplozaschite between three and chetyrehkamernymi profiles 60 mm in width. Work and give the effect of heat only the air chamber, in which the thickness of the air layer of not less than 5mm , And profiles with a width of 60 mm can only go on the road to the fragmentation of air chambers in the departments of 2-4 mm in width. With regard to steel termovkladyshami, it is possible to obtain an increase in resistance to heat, but it proved too expensive. Therefore, the windows «Thiessen» have four heat-insulating chamber width of at least 5 mm, and, based on the requirements of statics, determine the fifth, inner chamber of steel. The total required width on the basis of these two reasons, the system was 71 mm. High heat resistance profile system increases the heat resistance shown windows as a whole. By design data for the profile of «Thiessen» with the same insulating glass unit, and with respect to the square to square glass products 0.7 this important indicator increased by 0.03 m2S/Vt.

2. Reducing «fringe effect» of the window, thanks width 71 mm and a height of 20 mm pinch insulating glass unit.
An analysis of isotherms profile system showed a significant decline «fringe effect» insulating glass unit, that is, there is no condensation on its perimeter.

3. In the window can install double-glazed windows in width to 47 mm.
The economic situation in many regions are still such that more than justified the use of split-window. When increasing the width of the air layer insulating glass unit to 2 mm in the range of 10 to 15-16 mm gives an average increase in its resistance to heat at 0.02 m2S/Vt. As a standard insulating glass unit for the system «Thiessen» adopted the best overall thickness of 36 mm.

4. Compound (a mixture of raw material) prepared for profiles of hard Russian climate.
Plastic boxes must withstand the most severe frosts, so in its composition paid special attention to the impact strength modifier. Profile on the perception of climate impacts of the «hardy execution»; the Vicat softening temperature is 89 C; resilience of Sharpi 44 kDZh / m2; strength corner joints exceeds the requirements of the rules in two or three times!; Confirmed the longevity of 50 years of conditional use (for the moderate climate) and 20 - to the north.

5. High reliability and static formoustoychivost system through high moment of inertia of steel amplifiers, and the strength of the PVC profile.
Moment of inertia of the impost is twice that of other core systems.

6. The height of the porch: 8mm from the outside, inside the 9mm.
This ensures a safe height porch stvorok attachment to the frame and ample opportunity to adjust hardware. Together with elastic seals special form, it provides high density and noise insulation windows. At the same time, if necessary, the windows could be installed climate valve « Regel-Air »

7. In the designs of windows «Thiessen» apply svarivaemye seals of thermoplastic elastomers (TPE) gray.
Gray is the new seals attached to the windows, elegant design. Outstretched seals are welded together with profiles that speeds up and simplifies the manufacture of windows.

8. Axial size of the installation of fittings of 13 mm anti improves the quality of windows «Thiessen».

9. Disqualification of water and ventilation of faltsev double-glazed windows are on the outer chamber.

10. Profiles are elegant design with a gradient of 45 ° and with an impeccable surfaces.